Small Holes (Under 6cm): The Spackle Method
For nail holes, small dents, and holes under 6cm: clean the area (remove any loose drywall paper or debris). Fill with lightweight spackle or joint compound using a putty knife. Feather the edges out beyond the hole. Allow to dry completely (colour changes from white to bright white when dry). Sand smooth with 120-grit sandpaper. Prime the repaired area (essential — unprimed repairs show through paint as dull spots). Paint. For most small repairs, one or two fill-sand-prime-paint cycles gives an invisible result.
Medium Holes (6–15cm): California Patch Method
The California (peel-and-stick mesh) patch method: cut a piece of drywall slightly larger than the hole (e.g., for a 10cm hole, cut a 15cm square). Score the paper on one side of the patch and snap — the centre drywall falls away leaving a paper flap border. Apply joint compound around the hole, press the patch in place using the paper flaps as a bonding surface. Apply 2–3 coats of joint compound, feathering each 10–15cm beyond the patch. Sand, prime, paint.
Large Holes (15cm+): The Backing Strip Method
Cut the damaged area into a clean rectangle. Cut a replacement drywall piece the same size. Install backing strips (thin wood strips or special drywall backing clips) across the hole to give the patch something to screw into. Screw the patch to the backing strips. Apply joint compound over all seams, embedding drywall mesh tape in the first coat. Apply 3–4 coats total, feathering each coat progressively wider. Sand, prime, paint. Patience with drying time between coats is the difference between a professional and amateur result.