The short version
A Passive House (Passivhaus in German, where the standard began) is a building so well insulated and airtight that it barely needs a heating system. Instead of burning fuel to replace heat that leaks out, it keeps the heat it already has: from the sun through the windows, from cooking, from appliances, even from the people inside.
It isn't a style or a brand. It's a performance standard set by the Passive House Institute in Darmstadt, and a building only earns the name if it meets measurable targets.
The numbers a Passive House has to hit
- Heating demand of no more than 15 kWh per square metre per year. A typical older house in Germany or the UK uses somewhere between 100 and 200.
- Airtightness of no more than 0.6 air changes per hour at 50 pascals of pressure, tested on site with a blower door.
- Total primary energy for heating, hot water and electricity kept within a set limit.
- Comfort: rooms should stay above about 20°C in winter and overheat (above 25°C) for no more than 10% of the year.
The five principles that get it there
1. Thick, continuous insulation
Walls, roof and floor are wrapped in insulation, often 250–400 mm of it, with no gaps. The goal is a warm envelope where the inside surface of an outside wall feels almost as warm as the room.
2. Triple-glazed windows
Windows are usually the weakest point of any building. Passive House windows are triple-glazed with insulated frames, and the largest are placed on the sunny side so winter sun adds free heat.
3. No thermal bridges
A thermal bridge is anywhere heat can sneak out through a solid path, such as a steel balcony bracket, a concrete lintel or the edge of a floor slab. The design details these out one by one.
4. An airtight layer
Draughts carry heat away. A continuous airtight membrane runs around the whole building, and every pipe and cable that passes through it is sealed.
5. Ventilation with heat recovery
An airtight house needs fresh air brought in deliberately. A mechanical ventilation unit (MVHR) supplies filtered fresh air to living rooms and bedrooms and extracts stale air from kitchens and bathrooms. A heat exchanger passes around 75–90% of the warmth from outgoing air to incoming air. The result is fresh air all the time without opening a window in January.
What it costs
Building to the standard from scratch typically adds somewhere around 5–15% to construction costs compared with a house built to minimum regulations, depending on the country, the designer's experience and how simple the building's shape is. Compact, boxy forms are much cheaper to make airtight than complicated ones.
That premium is recovered through very low heating bills over the life of the building, plus a level of comfort that's hard to put a price on: no cold spots, no draughts, no condensation on windows, and steady temperatures day and night.
Can an existing home become a Passive House?
Retrofitting to the full standard is possible but expensive and disruptive. There's a separate, slightly relaxed retrofit standard called EnerPHit for exactly this reason. For most homeowners, the more realistic approach is to borrow the principles step by step:
- Seal draughts around doors, windows, loft hatches and floorboards.
- Top up loft insulation and insulate walls where it's practical.
- Replace windows with high-performance units when they're due anyway.
- Add mechanical ventilation once the house is tight enough to need it.
Doing these in order matters. Sealing and insulating first means any new heating system, such as a heat pump, can be smaller and cheaper to run.
Is it worth it?
If you're building new, Passive House is one of the most reliable ways to future-proof a home against rising energy prices. If you're renovating, aim for the principles rather than the certificate. Each step pays back on its own, and together they get you surprisingly close.